This meter swings proportionately to the RF output (outgoing signal) while transmitting.ġ The S/RF-SWR-CAL switch must be in the S/RF position. Prolonged transmitting without an antenna,or a poorly matched antenna.
COBRA 29 WX NW ST FULL
The Dimmer controls the brightness of the front panel, signal strength meter and channel display.Ģ Full counterclockwise rotation opens the "gate" allowing all signals in.īe sure the antenna is properly connected to the radio before transmitting. NB-ANL/ANL/ OFF (Noise Blanker / Automatic Noise Limiter) Switch While previous systems only "blanket out" or limit noise in higher sound frequencies, the SoundTracker™ gives you clearer, cleaner reception to improve CB communications while on the air. Swings proportionately to strength of incoming signal when receiving. When switched to SWR position the meter needle should ideally be as far to the left as possible. SWR calibration is done to properly adjust the length of the antenna and to monitor the quality of the coaxial cable and all RF connections. Make sure the power cord, antenna and microphone are connected to their proper connectors before starting.ġ The CB/PA button should be in the CB position. Note Because many newer trucks feature fiberglass door Second choice is on the center of the trunk. Note For optimum performance in passenger cars the ideal antenna location is on the center of the roof.
Turns itself on & off.Ĥ In a negative grounded vehicle, connect the red lead of the DC power cord to
COBRA 29 WX NW ST MANUAL
If there The mounting must be mechanically strong, conveniently located.ģ Connect the antenna cable plug to the receptacle marked "ANT" on the back ofĢ9 WX NW ST manual 3.3 6/15/99 2:53 PM īefore installing the CB radio, visually check the emergency weather alert automatically when ignition is turned on. Cobra 29 WX NW ST | User Manual - Ī3 SoundTracker™ Customer Support Installation Location 2 Mounting and Connection 2 Antennas CB Antenna 6 Marine Installation 6 Ignition Noise Interference 7 Operating Your 29 WX NW ST Turning On Your CB 8 Setting Channel Selector 9 Calibrate For SWR (Standing Wave Ratio 10 To Receive 12Ģ9 WX NW ST manual 3.3 6/ at a convenient angle.ġ Hold the radio with the mounting bracket in the exact desired location.Cobra 29 WX NW ST manual content summary:
0 kommentar(er)
